Danfoss MCO 305 Operating Instructions Manual

Also see for MCO 305: Design guide Operating instructions Design guide

1 Introduction1.1 Available Literature for VLTAutomationDrive, MCO 305 and MCT 10Motion Control Tool- The MCO 305 Design Guide entails all technicalinformation about the option board andcustomer design and applications.- The MCO 305 Command Reference completes theMCO 305 Design Guide with detailed descriptionof all commands available for programming MCO305.- The VLT AutomationDrive Operating Instructionsprovide the necessary information for getting thefrequency converter up and running.- The VLT AutomationDrive Programming Guideprovides complete descriptions of all parametersin the frequency converter.- The VLT AutomationDrive Design Guide entails alltechnical information about the frequencyconverter and customer design and applications.- The VLT AutomationDrive Profibus OperatingInstructions provide the information required forcontrolling, monitoring and programming thedrive via a Profibus fieldbus.- The VLT AutomationDrive DeviceNet OperatingInstructions provide the information required forcontrolling, monitoring and programming thedrive via a DeviceNet fieldbus.- The VLT AutomationDrive MCT- 10 OperatingInstructions provide information for installationand use of the software on a PC.Danfoss Drives technical literature is also available onlineat www.danfoss.com/drives.1.2 Symbols and ConventionsSymbolsThe following symbols are used in this manual.WARNINGIndicates a potentially hazardous situation which, if notavoided, could result in death or serious injury.CAUTIONIndicates a potentially hazardous situation which, if notavoided, may result in minor or moderate injury. It mayalso be used to alert against unsafe practices.CAUTIONIndicates a situation that may result in equipment orproperty-damage-only accidents.NOTEIndicates highlighted information that should be regardedwith attention to avoid mistakes or operate equipment atless than optimal performance.ApprovalsConventionsThe information in this manual follows the system anduses the typographical features described below to thegreatest extent possible:Menus and FunctionsMenus and functions are printed italics, forexample:Controller→ Parameters.Commands and ParametersCommands and parameter names are written in capitals,for example: AXEND and KPROP; Parameters are printed initalics, for example: Proportional factor.Parameter OptionsValues for use to select the parameter options are writtenin brackets, e.g. [3].KeysThe names of keys and function keys are printed inbrackets, for example the control key [Cntl] key, or just[Cntl], the [Esc] key or the [F1] key.Introduction MCO 305 Operating InstructionsMG.33.K3.02 - VLT® is a registered Danfoss trademark 31 1