Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

All digital input/output and analog input/output terminalsare multifunctional. All terminals have factory defaultfunctions suitable for the majority of water applications,but if other special functions are required, they must beprogrammed in parameter groups 5-** Digital In/out or 6-**Analog In/out.6.1.1 Quick Menu ModeThe GLCP provides access to all parameters listed underthe Quick Menus. To set parameters using the [QuickMenu] key:Pressing [Quick Menu] the list indicates the different areascontained in the Quick menu.Efficient parameter set-up for water applicationsThe parameters can easily be set up for the vast majorityof the water and wastewater applications only by usingthe [Quick Menu].The optimum way to set parameters through the [QuickMenu] is by following the below steps:1. Press [Quick Setup] for selecting basic motorsettings, ramp times, etc.2. Press [Function Setups] for setting up therequired functionality of the frequency converter- if not already covered by the settings in [QuickSetup].3. Select between General Settings, Open LoopSettings and Closed Loop Settings.It is recommended to do the set-up in the order listed.130BP064.10Q1 My Personal MenuQ2 Quick SetupQ3 Function SetupsQ5 Changes Made40.0% 4.84 A 1(1)Quick MenusIllustration 6.1 Quick Menu ViewPar. Designation [Units]0-01 Language1-20 Motor Power [kW]1-22 Motor Voltage [V]1-23 Motor Frequency [Hz]1-24 Motor Current [A]1-25 Motor Nominal Speed [RPM]3-41 Ramp 1 Ramp up Time [s]3-42 Ramp 1 Ramp down Time [s]4-11 Motor Speed Low Limit [RPM]4-13 Motor Speed High Limit [RPM]1-29 Automatic Motor Adaptation (AMA)Table 6.2 Quick Setup parameters.SeeIf No Operation is selected in terminal 27 no connection to+24 V on terminal 27 is necessary to enable start.If Coast Inverse (factory default value) is selected inTerminal 27, a connection to +24 V is necessary to enablestart.NOTICEFor detailed parameter descriptions, see .6.1.2 Q1 My Personal MenuParameters defined by the user can be stored in Q1 MyPersonal Menu.Select My Personal Menu to display only the parameters,which have been pre-selected and programmed aspersonal parameters. For example, a pump or equipmentOEM may have pre-programmed these to be in MyPersonal Menu during factory commissioning to make onsite commissioning/fine tuning simpler. These parametersare selected in par. 0-25 My Personal Menu. Up to 20different parameters can be defined in this menu.Parameter 20-21 Setpoint 1Parameter 20-93 PID Proportional GainParameter 20-94 PID Integral TimeTable 6.3 Q1 My Personal Menu6.1.3 Q2 Quick SetupThe parameters in Q2 Quick Setup are the basicparameters which are always needed to set-up thefrequency converter to operation.How to programme the freque... Operating InstructionsMG20Y202 Danfoss A/S © Rev. 06/2014 All rights reserved. 616 6