Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

5-30 Terminal 27 Digital OutputOption: Function:[180] Clock Fault[181] Prev. Maintenance[182] Deragging[183] Pre/Post Lube[188] AHF Capacitor Connect[189] External Fan Control[190] No-Flow[191] Dry Pump[192] End Of Curve[193] Sleep Mode[194] Broken Belt[195] Bypass Valve Control[198] Drive Bypass[199] Pipe Filling[200] Full capacity[201] Pump 1 running[202] Pump 2 running[203] Pump 3 running[204] Pump 4 running[205] Pump 5 running[206] Pump 6 running[207] Pump 7 running[208] Pump 8 running[209] Pump 9 running5-40 Function RelayOption: Function:Select options to define thefunction of the relays.The selection of each mechanicalrelay is realised in an arrayparameter.[0] No operation[1] Control Ready[2] Drive ready[3] Drive rdy/rem ctrl[4] Stand-by / no warning[5] Running[6] Running / no warning[8] Run on ref/no warn[9] Alarm[10] Alarm or warning[11] At torque limit[12] Out of current range[13] Below current, low[14] Above current, high[15] Out of speed range[16] Below speed, low[17] Above speed, high[18] Out of feedb. range[19] Below feedback, low[20] Above feedback, high5-40 Function RelayOption: Function:[21] Thermal warning[25] Reverse[26] Bus OK[27] Torque limit & stop[28] Brake, no brake war[29] Brake ready, no fault[30] Brake fault (IGBT)[33] Safe stop active[35] External Interlock[36] Control word bit 11[37] Control word bit 12[40] Out of ref range[41] Below reference, low[42] Above ref, high[45] Bus ctrl.[46] Bus ctrl, 1 if timeout[47] Bus ctrl, 0 if timeout[60] Comparator 0[61] Comparator 1[62] Comparator 2[63] Comparator 3[64] Comparator 4[65] Comparator 5[70] Logic rule 0[71] Logic rule 1[72] Logic rule 2[73] Logic rule 3[74] Logic rule 4[75] Logic rule 5[80] SL digital output A[81] SL digital output B[82] SL digital output C[83] SL digital output D[84] SL digital output E[85] SL digital output F[155] Verifying Flow[160] No alarm[161] Running reverse[164] Local ref active, not OFF[165] Local ref active[166] Remote ref active[167] Start command activ[168] Hand mode[169] Auto mode[180] Clock Fault[181] Prev. Maintenance[183] Pre/Post Lube[188] AHF Capacitor Connect[189] External Fan Control[190] No-Flow[191] Dry Pump[192] End Of CurveHow to programme the freque... Operating Instructions78 Danfoss A/S © Rev. 06/2014 All rights reserved. MG20Y20266