212 Print Media GuidelinesFILE LOCATION: C:\Users\fxstdpc-admin\Desktop\0630_UG??\Mioga_SFP_UG_FM\Mioga_SFP_UG_FM\section14.fmD E L L C O N F I D E N T I A L – P R E L I M I N A RY 9 / 1 3 / 1 0 - F O R P R O O F O N LY• Do not remove the tray while printing is in progress.• Ensure that the paper is properly loaded in the tray.• Flex the paper back and forth, and then fan them. Straighten the edges of thestack on a level surface.Selecting Pre-Printed Media and LetterheadsWhen selecting pre-printed and letterhead paper for the printer:• Use grain long paper for best results.• Use only forms and letterheads printed using an offset lithographic orengraved printing process.• Select paper that absorb ink, but does not bleed.• Avoid paper with rough or heavily textured surfaces.• Use paper printed with heat-resistant inks designed for use in xerographiccopiers. The ink must withstand temperatures of 225 °C (437 °F) withoutmelting or releasing hazardous emissions.• Use inks that are not affected by the resin in the toner or the silicone in thefuser. Inks that are oxidation-set or oil-based should meet these requirements;latex inks might not. If you are in doubt, contact your paper supplier.Selecting Pre-Punched PaperWhen selecting pre-punched paper for the printer:• Test paper from several manufacturers before ordering and using largequantities of pre-punched paper.• Paper should be punched at the paper manufacturer and not drilled into paperalready packaged in a ream. Drilled paper can cause jams when multiplesheets feed through the printer. This may result in a paper jam.
