2.3.When the option you want to set appears, press Select ( ) to access the option.4.Change the setting using the Scroll ( or ) buttons or enter the value using the number keypad.5.Press Select ( ) to save the selection.6.Repeat steps 3 through 6 , as needed.7.Press Cancel ( ) to return to the Standby mode.8.Scan to Fax ServerFax server will decipher the fax/e-mail data to send out the job. The e-mail is automatically processed by faxserver and sent to the given recipient.First, the printer sends the scanned data to the fax server. Then, the fax server uses PSTN to send a fax/e-mail data to recipient.To use fax server features as scan to e-mail, you first need to configure the network settings. See "DellPrinter Configuration Web Tool" for network parameters.Press Scroll ( or ) to highlight Scan and then press Select ( ).1.Press Scroll ( or ) to highlight Fax Server and then press Select ( ).2.Enter the remote fax phone number using the number keypad.3.If you place a single document face down on the document glass, skip to step 6 .4.Press Scroll ( or ) to highlight the duplex option, Off , 2side or 2->1 side rotate and then pressSelect ( ).Off : For originals that are printed on one side only.2side : For originals that are printed on both sides.2->1 side rotate : For originals that are printed on both sides. But the back is rotated 180degrees.5.Press Start ( ) or Select ( ).6.The printer begins scanning and then sends the fax.Press Cancel ( ) to return to the Standby mode.7.
