290Fax ProblemsCondition Suggested solutionsReceiving fax calls are not beinganswered by the printer• Receive Mode set to Tel mode. (manual receive mode)• The rings-to-answer setting might not be set correctly. (Under Ans/Fax mode, set theRing to Answer to a digit greater than the Ring to Answer setting for the TAD.)• The DPRD feature might be turned on, but you do not have the service, or you dohave the service and the feature is not set correctly.• The fax line cord might not be correctly connected, or the fax line cord is faulty.• The printer might not be able to detect Receiving fax tones because the answeringmachine is playing a voice message.• A voice-messaging service might be interfering with the printer as it attempts toanswer calls.• Fax Line might have signal integration issues. Please carry out Fax Line Test fromOp-panel to confirm line status. See "Testing Fax line connection".• The printer is monitoring line condition while it is receiving or sending a fax job. If anerror occurs during the transmission and the ECM Mode setting is On, the printermay request that the portion of the fax job to be resent. You should turn off ECMMode only if you are having trouble sending or receiving a fax job, and you are willingto accept the errors in the transmission job. Turning off the setting might be usefulwhen you are trying to send a fax long distant or receive from long distant (example:other countries etc.)• The printer might be out of paper and the memory is full.The printer cannot receive faxesfrom an extension telephone.• The fax cable might not be securely connected.• The printer dialing mode might be incorrectly set, or the extension phone might beincorrectly set.Faxes are not receivedautomatically.• The Fax mode should be selected.• Make sure that there is paper in the paper tray.• Check to see if the display shows Memory Full.The Receiving fax has blankspaces or is received inpoor-quality.• A noisy phone line can cause line errors.• Check your printer by making a copy.Receiving faxes are too light. The printer might be running out of toner while printing a fax. Under Toner emptyconditions, the printer will store the fax job into memory, as soon as possible, replacethe print cartridge, and then reprint the fax.Faxes are printed on two pagesinstead of one.The auto reduction setting may be turned Off, try enabling this setting
