Inc separation between the equipment and receiver.Connect the equipment into an outlet on a circuit from that to which the receiver isconnected.Consult your point of pu ervice representative for additional suggestions.facturer is not responsible for any radio or television interference by using other thanrecommended cables or by unauthorized changes o ations to this equipment. Unauthorizedchanges or modifications co the user's authority to operate this equipment.NO To assure compliance with FCC regulations on electromagneti erence for a Class Acomputing device, use a properly shielded and CABLE. Use of a substitute cable notproperly shielded and ground lt in a violation of FCC regulations.FCC Ideon InformationThe following informati rovided on the device or devices covered in this document in compFCC regulations:Model number: Dell™ Multifunction C r PrinterCompany nameDell Inc.One Dell WayRound Rock, Texas 78682 USA512-nformationThis device, IEEE 802.11g Wireless LAN ter, complies with Part 15 of the FCC Rules.Operation is subject to the following two conditio this device may not cause harmfulinterference, and (2) this devi ept any interference received; including interference that maycau d operation.Warning: Changes or modifications to this uni pressly approved by the partyresponsible for compliance could void authority to operate the equipment.Tested y with FCC standard. FOR HOME OR OFFICE USE.FCC ion Exposure Statement:This equipment complies with FCC RF radiation exposure limits set an uncontrolledenvironment, under 47 CFR 2.1093 paragraph (d)(2).This Transmitter must not be co-located or operating in conjunc h any other antenna ortransmitter.The E 802.11g Wireless LAN USB Adapter has been tested to the sure requirements(Specific Absorbtion Rate).Industry Canada Compliance Statement
