3 - 102Chapter 3 Removal and Replacement Procedures (RRPs)Version 1 2006.11.28Removal 71 FAN (PL13.5.10)Steps 1 through 13 are for reference. Before removing this component, check that Steps 1 through 13have been performed.1) Open the FRONT COVER (PL13.2.1).2) Remove the FUSER.(Removal 8)3) Remove the REAR COVER. (Removal 49)4) Remove the COVER BOTTOM. (Removal 50)5) Remove the COVER POLE IN R.(Removal 51)6) Remove the COVER POLE R.(Removal 52)7) Remove the RIGHT COVER. (Removal 54)8) Remove the COVER POLE IN L. (Removal 57)9) Remove the COVER POLE L. (Removal 58)10) Remove the LEFT COVER. (Removal 59)11) Remove the TOP COVER. (Removal 68)12) Remove the BOX ASSY PRT AIO. (Removal 60)13) Remove the BOX ASSY FAX AIO. (Removal 62)14) Disengage the connector (P/J503) of the FAN (PL13.5.10) from the LOW VOLTAGE POWERSUPPLY (PL13.5.14).15) Release the harness of the FAN from the four clamps and pull it out of the hole on the printer.16) Remove the two screws (silver, tap, 8mm) that fix the PLATE DUCT (PL13.5.9) to the printer.17) Remove the two screws (silver, tap, 32mm) that fix the FAN to the printer.18) Remove the PLATE DUCT and FAN from the printer.Continues to the next page.Gnb03180KA14)15)15)17)17)16)16)18)
