2-146 Service ManualSensor (mailbox empty) late jam service check3 Check the above sensor for proper connection.Is the above sensor connected properly?Replace thesensor (outputpass through).Go to “Highcapacity stackersensor (passthrough)removal” onpage 4-145.Go to “5-binmailbox sensor(pass through)removal” onpage 4-91.Go to “Outputexpander sensor(pass through)removal” onpage 4-170.Replace theconnection.4 Perform a print test using the output option.Does the error continue?Replace the outputoption. Problem solved.Step Check Yes No1 Check the output option for proper installation.Is the above component properly installed?Go to step 2. Remove thenreinstall the outputoption2 Check for obstructions in the media path between the basemachine and the output option.Is the media path free from obstructions?Go to step 3. Removeobstructions.3 Check the sensor (mailbox empty) for proper operation.1. Enter the diagnostic mode2. Select Output bin tests3. Select Sensor test4. Select Output bin x5. Observe the line item “mailbox empty”Does the display on the operator panel, change every timethe sensing area of the above sensor is interrupted orblocked.Go to step 5. Go to step 4.4 Check the above sensor for proper connection.Is the above sensor connected properly?Replace thesensor (mailboxempty).Go to “5-binmailbox sensor(media binempty) removal”on page 4-92.Replace theconnection.5 Perform a print test using the output option.Does the error continue?Replace the outputoption. Problem solved.Step Check Yes No
