Diagnostic aids 3-19To run the Finisher Sensor Test:1. Select Sensor Test from FINISHER TESTS.2. Select one of the four tests to perform:. Each of the tests displays the individual sensors that can bemanually actuated, and the display shows Open or Closed.• Staple SensorsCartridge Present sensorStaple Low sensorSelf-priming sensorHome signal sensor• Cover and DoorFinisher top cover sensorSide door sensor• Pass and MediaFinisher pass thruMedia sensor• Bin LevelFinisher bin emptyBin full sensorBin near full3. Press Back or Stop to exit the test.BASE SENSOR TESTThis test is used to determine if the sensors located inside the printer are working correctly.To run the Base Sensor Test:1. Select BASE SENSOR TEST from the DIAGNOSTICS menu.The following sensors are listed:• Toner Level– Toner level sensor (remove the cartridge and replace to actuate the sensor)• Input– Input sensor• Output– Output (exit) sensor• NarrowMedia– Output (exit) sensor• Front Door– Front door sensor2. Manually actuate the sensors to verify that each sensor switches from Open to Closed.3. Press Back or Stop to exit the test.PRINTER SETUPDefaultsUS/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.WARNING: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot beundone.Printed Page Count
