Diagnostic aids 3-21• To change a digit or character, press to increase or to decrease the value.• When the last digit is changed, press to validate the Configuration ID 1.If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on thescreen.If the process is successful, Submitting Selection appears on the display, followed by the currentvalue for Confirguration ID 2.4. Repeat the steps for entering the Configuration ID, and press .If the Configuration ID 2 is validated, Submitting Selection appears, and a check appears next toPrinter Setup.5. Restart the printer.Edge to EdgeWhen this setting is On, the text and graphics are shifted to the physical edges of the paper for all margins.When the setting is Off, the normal margins are restored.EP SETUPEP DefaultsThis setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimesthis is used to help correct print quality problems.To restore EP Defaults:1. Select EP Defaults from EP SETUP.2. Select Restore to reset the values to the factory settings, and select Do Not Restore to exit withoutchanging the settings.Fuser Temperature (Fuser Temp)This adjustment can be used to help solve some customer problems with paper curl on low grade papers andproblems with letterheads on some types of media.The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal.Fuser Page CountThe fuser page count can only be viewed and cannot be changed.To view the Fuser Page Count:1. Select Fuser Page Count from EP SETUP.2. Press Back to return to PRINTER SETUP.Warm Up TimeYou can change the amount of time the printer warms up before allowing pages to print by changing this settingfrom 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll heat upand helps reduce curl in some environments.TransferThe transfer can be adjusted to Low, Medium, or High. The default setting is Medium.
