Use ToJob Timeout0, 10–225 secondsSet the amount of time it takes for a network print job to be canceled.Notes:• “90 seconds” is the factory default setting.• A setting value of 0 disables the timeout.• If a value between 1 and 9 is selected, then Invalid appears on thedisplay, and the value is not saved.Banner PageOffOnAllow the printer to print a banner page.Note: Off is the factory default setting.TCP/IP menuTo access the menu, navigate to either of the following:• Network/Ports > Standard Network > Standard Network Setup > TCP/IP• Network/Ports > Network [x] > Network [x] Setup > TCP/IPNote: This menu is available only in network printers or printers attached to print servers.Use ToSet Hostname Set the current TCP/IP host name.Note: This can be changed only from the Embedded Web Server.IP Address View or change the current TCP/IP address.Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IPsettings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems thatsupport BOOTP and RARP.Netmask View or change the current TCP/IP netmask.Gateway View or change the current TCP/IP gateway.Enable DHCPOnOffSpecify the DHCP address and parameter assignment.Note: On is the factory default setting.Enable RARPOnOffSpecify the RARP address assignment setting.Note: Off is the factory default setting.Enable BOOTPOnOffSpecify the BOOTP address assignment setting.Note: On is the factory default setting.Enable AutoIPYesNoSpecify the Zero Configuration Networking setting.Note: Yes is the factory default setting.Enable FTP/TFTPYesNoEnable the built-in FTP server, which lets you send files to the printer using File TransferProtocol.Note: Yes is the factory default setting.Understanding the printer menus 162
