Safety informationConnect the power cord to a properly grounded electrical outlet that is near the product and easily accessible.Do not place or use this product near water or wet locations.CAUTION—POTENTIAL INJURY: This product uses a laser. Use of controls or adjustments or performance ofprocedures other than those specified herein may result in hazardous radiation exposure.This product uses a printing process that heats the print media, and the heat may cause the media to release emissions.You must understand the section in your operating instructions that discusses the guidelines for selecting print mediato avoid the possibility of harmful emissions.CAUTION—POTENTIAL INJURY: The lithium battery in this product is not intended to be replaced. There is adanger of explosion if a lithium battery is incorrectly replaced. Do not recharge, disassemble, or incinerate alithium battery. Discard used lithium batteries according to the manufacturer's instructions and localregulations.CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hotcomponent, allow the surface to cool before touching.CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or moretrained personnel to lift it safely.CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury orprinter damage:• Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.• Disconnect all cords and cables from the printer before moving it.• If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the latch on theright side of the tray toward the front of the tray until it clicks into place.• Use the handholds located on both sides of the printer to lift it.• Make sure your fingers are not under the printer when you set it down.• Before setting up the printer, make sure there is adequate clearance around it.Use only the power cord provided with this product or the manufacturer's authorized replacement.Use only the telecommunications (RJ‑11) cord provided with this product or a 26 AWG or larger replacement whenconnecting this product to the public switched telephone network.CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware ormemory devices sometime after setting up the printer, then turn the printer off, and unplug the power cordfrom the electrical outlet before continuing. If you have any other devices attached to the printer, then turnthem off as well, and unplug any cables going into the printer.CAUTION—SHOCK HAZARD: Make sure that all external connections (such as Ethernet and telephone systemconnections) are properly installed in their marked plug-in ports.This product is designed, tested, and approved to meet strict global safety standards with the use of specificmanufacturer's components. The safety features of some parts may not always be obvious. The manufacturer is notresponsible for the use of other replacement parts.CAUTION—POTENTIAL INJURY: Do not cut, twist, bind, crush, or place heavy objects on the power cord. Do notsubject the power cord to abrasion or stress. Do not pinch the power cord between objects such as furnitureand walls. If any of these things happen, a risk of fire or electrical shock results. Inspect the power cord regularlyfor signs of such problems. Remove the power cord from the electrical outlet before inspecting it.Safety information 8
