SNMP v1/v2cPurpose:To edit the detailed settings of SNMP v1/v2 protocol.To enter this page, click Edit SNMP v1/v2 Properties in the SNMP page.Values:Community Name Community Name(Read only) *1Sets the community name to access (read only) data using up to 31alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for community name in the previous settings will not be displayedon the screen. The default Read Community is public.Re-enter CommunityName (Read only)*1Enters the community name to access (read only) data again to confirm it.Community Name(Read/Write) *1Sets the community name to access (read and write) data using up to 31alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for community name in the previous settings will not be displayedon the screen. The default Read/Write Community is private.Re-enter CommunityName (Read/Write) *1Enters the community name to access (read and write) data again toconfirm it.Community Name(Trap) *1Sets the community name used for trap up to 31 alphanumeric characters.The original setting will remain valid if no input is made. Charactersentered for Community Name (Trap) in the previous settings will not bedisplayed on the screen. The default Trap Community is " " (NULL).Re-enter CommunityName (Trap)*1Enters the community name used for trap again to confirm it.Trap Notification 1-4 Trap Address TypeTrap AddressPort NumberNotifyNetwork*2Select the check boxes to notify trap occurrence. In this case, specify the IPaddress and IP socket in the following format:IPv4Specify the IP address and IP socket in the nnn.nnn.nnn.nnn:mmmmmformat. Each section of "nnn" is a variable value between 0 and 255. Notethat values 127 and 224-254 are not valid for the first three-digits only. IPsocket mmmmm is a variable value between 0 and 65,535.IPv6Specify the IP address and IP socket in thexxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:mmmmm format. Each sectionof "xxxx" is a hexadecimal variable value between 0 and ffff. IP socketmmmmm is a variable value between 0 and 65,535.Authenticate Error Trap Select the check box to notify Authenticate Error Trap.*1 The default value can be changed by using Dell Printer Configuration Web Tool.*2 This item is available only when Wi-Fi Direct is set to Enable.Dell™ Printer Configuration Web Tool 135
