Figure 10. Removing the intrusion switch1. intrusion switch 2. intrusion switch slot3. intrusion switch cable 4. intrusion switch connector on thesystem board5. cable routing clip (2)Next steps1. Install the intrusion switch.2. Follow the procedure listed in the After working inside your system section.Related LinksBefore working inside your systemAfter working inside your systemSafety instructionsInstalling the intrusion switchPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.Steps1. Insert the intrusion switch into the intrusion switch slot.2. Slide the intrusion switch until it locks into position.3. Route the intrusion switch cable through the cable routing tab.55
