Dell DL1300 Owner's Manual

Contents

Dell DL1300 Owner's Manual Manual pdf 86 page image

6. Close the processor shield by sliding it under the retention screw.7. Lower the socket lever and push it under the tab to lock it.Next stepsNOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessaryto maintain proper thermal conditions.1. Install the heat sink.2. If removed, reinstall the PCIe expansion card riser.3. If disconnected, reconnect the cables to the expansion card(s).4. Follow the procedure listed in the After working inside your system.5. While booting, press F2 to enter System Setup and verify that the processor information matches thenew system configuration.6. Run the system diagnostics to verify that the new processor operates correctly.Removing the processorPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should beperformed only by Dell certified service technicians.1. Follow the safety guidelines listed in the Safety instructions section.2. Keep the Phillips #2 screwdriver ready.3. If you are upgrading your system, download the latest system BIOS version from Dell.com/supportand follow the instructions included in the compressed download file to install the update on yoursystem.NOTE: You can update the system BIOS by using the Dell Lifecycle Controller.4. Follow the procedure listed in the Before working inside your system section.5. Remove the cooling shroud.6. Remove the heat sink.WARNING: The processor will be hot to touch for some time after the system has been powereddown. Allow the processor to cool before removing it.CAUTION: The processor is held in its socket under strong pressure. Be aware that the releaselever can spring up suddenly if not firmly held.Steps1. Release the socket lever by pushing the lever down and out from under the tab on the processorshield.2. Lift the lever upward until the processor shield lifts.CAUTION: The processor socket pins are fragile and can be permanently damaged. Be carefulnot to bend the pins in the processor socket when removing the processor out of the socket.3. Lift the processor out of the socket.86