support.dell.com System Software Solutions 4-195. Set the Screen area for your display to the appropriate size.6. Click OK.Installing the DualPoint Integrated Pointing DeviceDrivers (Windows 2000)DualPoint integrated pointing device drivers and associated utilities allow you to useand customize the integrated touch pad, track stick, or external mouse. To installthese drivers, perform the following steps.NOTICE: Use these steps to install touch pad drivers only if your computerhas a track stick. If your computer does not have a track stick, follow theinstructions in the next section, “Installing the Touch Pad Drivers.”1. Save your work in all open application programs because you will need to restartyour computer at the end of this procedure to complete the installation.2. Insert the System Utilities CD into the CD-ROM drive.3. Click the Start button, and then click Run.The Run dialog box appears.4. Type x:\win2000\touchpad\dual\setup, where x is the drive letter of yourCD-ROM drive, and click OK or press .5. Follow the instructions on the screen.6. After the files are copied to your hard-disk drive, remove the System Software CDfrom the CD-ROM drive, and click Finish to restart your computer.Installing the Touch Pad Drivers (Windows 2000)Touch pad drivers and associated utilities allow you to use and customize the inte-grated touch pad or external mouse. To install these drivers, perform the followingsteps.NOTICE: Use these steps to install touch pad drivers only if your computerdoes not have a track stick. If your computer has a track stick, follow theinstructions in the previous section, “Installing the DualPoint IntegratedPointing Device Drivers.”1. Save your work in all open application programs because you will need to restartyour computer at the end of this procedure to complete the installation.2. Insert the System Software CD into the CD-ROM drive.3. Click the Start button, and then click Run.The Run dialog box appears.4. Type x:\win2000\touchpad\single\setup, where x is the drive letter ofyour CD-ROM drive, and click OK or press .
