Appendix 1775 Replace the computer cover (see "Replacing the Computer Cover" on page 164).NOTICE: To connect a network cable, first plug the cable into the network deviceand then plug it into the computer.6 Connect your computer and devices to electrical outlets, and turn them on.Clearing CMOS SettingsCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions located in the Product Information Guide.1 Follow the procedures in "Before You Begin" on page 97.NOTE: The computer must be disconnected from the electrical outlet to clearthe CMOS setting.2 Remove the computer cover (see "Removing the Computer Cover" onpage 99).3 Reset the current CMOS settings:a Locate the 3-pin CMOS jumper (CLEAR CMOS) on the systemboard (see "System Board Components" on page 102).b Remove the jumper plug from the CMOS jumper (CLEAR CMOS)pins 2 and 3.c Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1and 2 and wait approximately five seconds.d Remove the jumper plug and replace it on the CMOS jumper(CLEAR CMOS) pins 2 and 3.4 Replace the computer cover (see "Replacing the Computer Cover" onpage 164).NOTICE: To connect a network cable, first plug the cable into the network port ordevice and then plug it into the computer.5 Connect your computer and devices to electrical outlets, and turnthem on.
