Using the Module BayAbout the Module BaySwapping Devices While the Computer Is Turned OffSwapping Devices While the Computer Is RunningUsing the CD or DVD TrayAdjusting the VolumeAdjusting the PictureAbout the Module BayYou can install devices such as a floppy drive, CD drive, CD-RW drive, DVD drive, DVD/CD-RW drive, Zipdrive, second hard drive, or second battery in the module bay.NOTICE: To prevent damage to the docking connector, do not remove or replace devices while thecomputer is connected to a docking device.Swapping Devices While the Computer Is Turned OffSave and close any open files, exit any open programs, and shut down the computer.1.If the computer is connected (docked) to a docking device, undock it.2.Close the display and turn the computer over.3.Slide and hold the latch release, and pull the device out of the bay.4.NOTICE: To prevent damage to devices, place them in a travel case when they are not installed inthe computer. Store devices in a dry, safe place, and avoid pressing down on them or placing heavyobjects on top of them.