70 Setting Up and Using Networks6 Disconnect the network cable from the computer and the modem.7 Disconnect the AC adapter cable from your wireless router to ensure thatthere is no power connected to the router.NOTE: Wait for a minimum of 5 minutes after disconnecting your broadbandmodem before continuing with the network setup.8 Insert a network cable into the network (RJ-45) connector on theunpowered broadband modem.9 Connect the other end of the network cable into the Internet network(RJ-45) connector on the unpowered wireless router.10 Ensure that no network or USB cables, other than the network cableconnecting the modem and the wireless router, are connected to thebroadband modem.NOTE: Restart your wireless equipment in the order described below toprevent a potential connection failure.11 Turn on only your broadband modem and wait for at least 2 minutes forthe broadband modem to stabilize. After 2 minutes, proceed to step 12.12 Turn on your wireless router and wait for at least 2 minutes for the wirelessrouter to stabilize. After 2 minutes, proceed to the step 13.13 Start your computer and wait until the boot process completes.14 See the documentation that came with your wireless router to do thefollowing in order to set up the wireless router:• Establish communication between your computer and your wireless router.• Configure your wireless router to communicate with yourbroadband router.• Find out your wireless router’s broadcast name. The technical term forthe name of your router’s broadcast name is Service Set Identifier (SSID)or network name.15 If necessary, configure your wireless network card to connect to the wirelessnetwork (see "Connecting to a WLAN" on page 71).
