Configuring System Information 119Defining Device IP AddressesThe IP Addressing page contains links for assigning interface and default gateway IP addresses, anddefining ARP and DHCP parameters for the interfaces. To open the IP Addressing page, clickSystem →IP Addressing in the tree view.Defining Default GatewaysThe Default Gateway page contains fields for assigning Gateway devices. Packets are forwarded tothe default IP when frames are sent to a remote network. The configured IP address must belong tothe same IP address subnet of one of the IP interfaces. To open the Default Gateway page, clickSystem→IP Addressing →Default Gateway in the tree view.The Default Gateway page contains the following fields:Default Gateway — The Gateway device IP address.Remove — Removes Gateway devices from the Default Gateway drop-down list, when selectedSelecting a Gateway Device:1 Open the Default Gateway page.2 Select an IP address in the Default Gateway drop-down list.3 Select the Active check box.4 Click Apply Changes.The gateway device is selected and the device is updated.Removing a Default Gateway Device:1 Open the Default Gateway page.2 Select the Remove check box to remove default gateways.3 Click Apply Changes.The default gateway entry is removed, and the device is updated.Defining Gateway Devices Using the CLI CommandsThe following table summarizes the equivalent CLI commands for setting fields displayed in theDefault Gateway page.Table 6-26. Default Gateway CLI CommandsCLI Command Descriptionip default-gateway ip-addressDefines a default gateway.no ip default-gateway Removes a default gateway.
