802.1x Commands 301FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell ContaxCLI\files\802.1X.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LYConsole(config)# interface gigabitethernet 1/0/15Console(config-if)# dot1x timeout quiet-period 3600dot1x timeout tx-periodUse the dot1x timeout tx-period Interface Configuration (Ethernet) modecommand to set the time interval during which the device waits for aresponse to an Extensible Authentication Protocol (EAP) request/identityframe from the client before resending the request. Use the no form of thiscommand to restore the default configuration.Syntaxdot1x timeout tx-periodsecondsno dot1x timeout tx-periodParametersseconds—Specifies the time interval in seconds during which the device waitsfor a response to an EAP-request/identity frame from the client beforeresending the request. (Range: 1–65535 seconds)Default ConfigurationThe default timeout period is 30 seconds.Command ModeInterface Configuration (Ethernet) modeUser GuidelinesThe default value of this command should be changed only to adjust tounusual circumstances, such as unreliable links or specific behavioralproblems with certain clients and authentication servers.ExampleThe following command sets the time interval during which the device waitsfor a response to an EAP request/identity frame to 3600 seconds.Console(config)# interface gigabitethernet 1/0/15Console(config-if)# dot1x timeout tx-period 3600