414 Port Monitor CommandsFILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell ContaxCLI\files\Port_Monitor.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LYUser GuidelinesThis command enables port copy between Source Port (src-interface) to aDestination Port (The port in context).The analyzer port for port ingress traffic mirroring should be the same port forall mirrored ports.The analyzer port for port egress traffic mirroring should be the same port forall mirrored ports.Following are restrictions apply for ports that are configured to be sourceports:• The port cannot be a destination port.The following restrictions apply to ports that are configured to be monitorports:• The port can’t be source port.• The port isn’t member in port-channel.• IP interface is not configured on the port.• GVRP is not enabled on the port.• The port is not a member in any VLAN, except for the default VLAN (willbe automatically removed from the default VLAN).• L2 protocols are not active on the copy dest. Port: LLDP, LBD, STP, LACP.The following restrictions apply to ports that are configured to be monitorports:• The port cannot be source port.• The port is not a member in port-channel.Notes:1. In this mode some traffic duplication on the analyzer port may be observed.For example:• Port 2 is being egress monitored by port 4.• Port 2 & 4 are members in VLAN 3.• Unknown Unicast packet sent to VLAN 3 will egress from port 4 twice,one instance as normal forward and another instance as mirrored fromport 2.
