Address Table Commands 393FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell ContaxCLI\files\Address_Table.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY• ethernet interface-list—Specifies a list of Ethernet ports. Separatenonconsecutive Ethernet ports with a comma and no spaces. Use a hyphento designate a range of ports.• port-channel port-channel-list—Specifies a list of port channels. Separatenonconsecutive port-channels with a comma and no spaces; use a hyphento designate a range of port channels.Default ConfigurationPorts are not forbidden to dynamically join multicast groups.Command ModeInterface Configuration (VLAN) modeUser GuidelinesUse this command to forbid a port to dynamically join (by IGMP, forexample) a multicast group.The port can still be a multicast router port.ExampleThe following example forbids forwarding of all multicast packets to gi1/0/1within VLAN 2.Console(config)# interface vlan 2Console(config-if)# bridge multicast forbidden forward-all addethernet gi1/0/1mac address-table staticUse the mac address-table static Global Configuration mode command toadd MAC-layer station source address to the MAC address table. Use the noform of this command to delete the MAC address.Syntaxmac address-table staticmac-address vlan vlan-id interface interface-id[permanent | delete-on-reset | delete-on-timeout | secure ]no mac address-table static [mac-address] vlan vlan-id