590 iSCSI CommandsFILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell ContaxCLI\files\iSCSI.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LYExampleThe following example enables iSCSI awareness globally.Console(config)# iscsi enableiscsi target portUse the iscsi target port Global Configuration mode command to configuresiSCSI target ports. Use the no form of this command to delete the iSCSItarget ports.Syntaxiscsi target porttcp-port-1 [tcp-port-2.… tcp-port-8] [address ip-address][name targetname]no iscsi target porttcp-port-1 [tcp-port-2.… tcp-port-8] [address ip-address]Parameters• tcp-port—Specifies the TCP port number or list of TCP port numbers onwhich iSCSI targets listen to requests. Up to 8 TCP ports can be defined inthe system, in one command or by using multiple commands. (Range:1–65536)• address ip-address—Specifies the iSCSI target IP address. If the no form isused and the TCP port to be deleted is one that was bound to a specific IPaddress, the IP address field must be present.• name targetname—Specifies the iSCSI target name. The name can bestatically configured, but it can also be obtained from iSNS or from thesendTargets response. The initiator must present both its iSCSI InitiatorName and the iSCSI Target Name to which it wishes to connect in the firstlogin request of a new session or connection. The name must comprisevalid characters, as specified by RFC 3722. (Length: 1–223 characters)Default ConfigurationiSCSI well-known ports 3260 and 860 are configured as the default targetports, but they can be removed just as any other configured target.