Dell PowerConnect W AirWave 7.2 | User Guide Discovering, Adding, and Managing Devices | 147Figure 107 Override Section of a Supported Controller’s Manage PagePerform these steps to override individual profile settings for an Dell controller that is part of a spectrum-modeDell AP group:1. Select a Spectrum-supported Dell controller that is referencing a Spectrum profile, and go to its APs/Devices> Manage page. Set it to Manage Read/Write mode.2. Under the Dell Overrides section, select Add New Dell Controller Override.3. In the Profile drop-down menu, select the Spectrum Profile type.4. In the Profile Instance drop-down menu, select the instance of the Spectrum profile used by the controller.5. In the Field drop-down menu, select the setting you would like to change (such as an Age-Out setting or aSpectrum Band), and enter the overriding value below it.6. Select Add to save your changes.7. To create additional overrides for this controller, select Add New Dell Controller Override again.8. When you have finished, select Save and Apply.You can also use the above procedure to turn on Spectrum mode for radio profiles on one particular controller, oruse the overrides to point your radio profile to a non-default Spectrum profile for just this controller.
