40 | Configuring AWMS Dell PowerConnect W AirWave 7.2 | User Guide8. Locate the Additional AMP Services section, and adjust settings as required. Table 14 describes the settingsand default values of this section.9. Locate the Performance Tuning section. Performance tuning is unlikely to be necessary for many AWMSimplementations, and likely provides the most improvements for customers with extremely large Pro orEnterprise installations. Please contact Dell support if you think you might need to change any of thesesettings. Table 15 describes the settings and default values of this section.Failures BeforeStopping (0-20) 1 Sets the default number of upgrade failures before AWMS pauses the upgrade process.User intervention is required to resume the upgrade process. Setting this value to 0disables this function.Table 14 AMP Setup > General > Additional AMP Services Fields and Default ValuesSetting Default DescriptionEnable FTP Server No Enables or disables the FTP server on AMP. The FTP server is only used to manage CiscoAironet 4800 APs. Dell PowerConnect W recommends disabling the FTP server if you donot have any Cisco Aironet 4800 APs in the network.Enable RTLS Collector No Enables or disables the RTLS Collector, which is used to allow ArubaOS controllers to sendsigned and encrypted RTLS (real time locating system) packets to VisualRF-- in otherwords, AWMS becomes the acting RTLS server. The RTLS server IP address must beconfigured on each controller. This function is used for VisualRF to improve locationaccuracy and to locate chirping asset tags. This function is supported only for DellPowerConnect W, Alcatel-Lucent and Aruba Networks devices.With selection of Yes, the following additional fields appear, which you should populate tomatch the settings configured on the controller: RTLS Port—Specify the port for the AWMS RTLS server. RTLS Username—Enter the user name used by the controller to decode RTLSmessages. RTLS Password—Enter the RTLS server password that matches the controllers’ value.Use Embedded MailServerYes Enables or disables the embedded mail server that is included with AWMS.This fieldsupports a Send Test Email button for testing server functionality. This button prompts youwith a To and From field in which you must enter valid email addresses, and a button tosend a test email.Process User RoamingTraps from Cisco WLCYes AMP now parses client association and authentication traps from Cisco WLC controllersto give real time information on users connected to the wireless network.Enable AMON datacollectionYes Allows AMP to collect enhanced data from Dell PowerConnect W devices on certainfirmware versions; see the Dell PowerConnect W AirWave Best Practices Guide in Home> Documentation for more details.Table 15 AMP Setup > General > Performance Tuning Fields and Default ValuesSetting Default DescriptionMonitoringProcesses Based on thenumber ofcores for yourserverOptional setting configures the throughput of monitoring data. Increasing thissetting allows AWMS to process more data per second, but it can takeresources away from other AWMS processes. Please contact Dell support ifyou think you might need to increase this setting for your network.Maximum Number ofConfigurationProcesses5 Increases the number of processes that are pushing configurations to yourdevices, as an option. The optimal setting for your network depends on theresources available, especially RAM. Please contact Dell support if you thinkyou might need to increase this setting for your network.Table 13 AMP Setup > General > Default Firmware Upgrade Options Fields and Default Values (Continued)Setting Default Description
