Dell PowerConnect W AirWave 7.2 | User Guide Creating and Using Templates | 153Configuring General Template Files and VariablesThis section describes the most general aspects of configuring AP device templates and the most commonvariables: Configuring General Templates Using Template Syntax Using Directives to Eliminate Reporting of Configuration MismatchesFetch None Selects an AP from which to fetch a configuration. The configuration will be turned into a templatewith basic AP specific settings like channel and power turned into variables. The variables are filledwith the data on the APs/Devices > Manage page for each AP.Name None Defines the template display name.AP Type Cisco IOS (AnyModel)Determines that the template applies to APs or devices of the specified type. If Cisco IOS (Any Model)is selected, the template applies to all IOS APs that do not have a version specific template specified.Reboot APs AfterConfiguration ChangesNo Determines reboot when AWMS applies the template, copied from the new configuration file to thestartup configuration file on the AP. If No is selected, AWMS uses the AP to merge the startup andrunning configurations. If Yes is selected, the configuration is copied to the startup configuration fileand the AP is rebooted.This field is only visible for some devices.Restrict to this version No Restricts the template to APs of the specified firmware version. If Yes is selected, the template onlyapplies to APs on the version of firmware specified in the Template Firmware Version field.Template firmwareversionNone Designates that the template only applies to APs running the version of firmware specified.Community String None If the template is updating the community strings on the AP, enter the new community string AWMSshould use here. AWMS updates the credentials it is using to communicate to the device after thedevice has been managed.Telnet/SSH Username None If the template is updating the Telnet/SSH Username on the AP, enter the new username AWMSshould use here. AWMS updates the credentials it is using to communicate to the device after thedevice has been managed.Telnet/SSH Password None If the template is updating the Telnet/SSH password on the AP, enter the new Telnet/SSH passwordAWMS should use here. AWMS updates the credentials it is using to communicate to the device afterthe device has been managed."enable" Password None If the template is updating the enable password on the AP, enter the new enable password AWMSshould use here. AWMS updates the credentials it is using to communicate to the device after thedevice has been managed.SNMPv3 Username None If the template is updating the SNMP v3 Username password on the AP, enter the new SNMPUsername password here. AWMS updates the credentials it is using to communicate to the deviceafter the device has been managed.Auth Password None If the template is updating the SNMP v3 Auth password on the AP, enter the new SNMP Usernamepassword here. AWMS updates the credentials it is using to communicate to the device after thedevice has been managed.Privacy Password None If the template is updating the SNMP v3 Privacy password on the AP, enter the new SNMP Usernamepassword here. AWMS updates the credentials it is using to communicate to the device after thedevice has been managed.SNMPv3 Auth Protocol MD5 Specifies the SNMPv3 Auth protocol, either MD5 or SHA-1.SNMPv3 PrivacyProtocolDES Specifies the SNMPv3 Privacy protocol, either DES or AES.Table 89 Groups > Templates > Add Template Fields and Default Values (Continued)Setting Default Description
