Dell PowerConnect W AirWave 7.2 | User Guide Creating, Running, and Emailing Reports | 223Figure 158 Custom Options Page IllustrationThe left pane of the Custom Options section lists all available data that can be included in the report. Forexample, if the data you want to include is in the RF Health report, select RF Health to view a list of all availableradio frequency information. Then, simply drag the desired data from the Available Options list on the left to theSelected Options pane on the right. The order of the data in the Selected Options section is the order that it willappear in the report. The data can be reordered by dragging an item up or down the list.4. Below the Custom Options panes are the Report Restrictions, Scheduling Options, Report Visibility, andEmail Options sections. Choose the parameters as needed for your report, especially a Report Start andReport End.5. When finished, select Add and Run to add the report to your list and run it immediately, Run Now to runwithout being added to the list, Add to add but not run the report, and Cancel to exit this page.Using the Capacity Planning ReportThe Capacity Planning Report tracks device bandwidth capacity and throughput in device groups, folders, andSSIDs. This report assists in analyzing device capacity and performance on the network, and such analysis canhelp to achieve network efficiency and improved experience for users.This report is based on interface-level activity. The information in this report can be sorted by any column headerin sequential or reverse-sequential order by selecting the column heading.Refer also to the “Using the Network Usage Report” on page 232 for additional bandwidth information.The following figures and Table 128 illustrate and describe the contents of the Capacity Planning Report.
