54 | Configuring AWMS Dell PowerConnect W AirWave 7.2 | User Guide Enter AMP in the service column and https in the protocol column. Select Save.5. Edit the existing groups or users in TACACS to use the “AMP service” and define a role for the group or user. The role defined on the Group Setup page in ACS must match the exact name of the role defined on theAMP Setup > Roles page. The defined role should use the following format: role=. One example is asfollows:role=DormMonitoringAs with routers and switches, AWMS does not need to know usernames.6. AWMS also needs to be configured as an AAA client. On the Network Configuration page, select Add Entry. Enter the IP address of AWMS as the AAA Client IP Address. The secret should be the same value that was entered on the AMP Setup > TACACS+ page.7. Select TACACS+ (Cisco IOS) in the Authenticate Using dropdown menu and select submit + restart.What Next? Go to additional tabs in the AMP Setup section to continue additional setup configurations. Complete the required configurations in this chapter before proceeding. Dell support remains available to you forany phase of AWMS installation.Configuring RADIUS Authentication and AuthorizationFor RADIUS capability, you must configure the IP/Hostname of the RADIUS server, the TCP port, and theserver shared secret. Perform these steps to configuration RADIUS authentication:1. Go to the AMP Setup > Authentication page. This page displays current status of RADIUS. Figure 25illustrates this page.NOTE: AWMS checks the local username and password store before checking with the TACACS+ server. If the user is foundlocally, the local password and local role apply. When using TACAS+, it is not necessary or recommended to define users on theAWMS server. The only recommended user is the backup administrator, in the event that the TACAS+ server goes down.
