Next stepsFollow the procedure listed in After working inside your system.Installing the SD vFlash cardPrerequisites1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.CAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled inSystem Setup.Steps1. Locate the SD card connector on the internal dual SD module. Align the SD card appropriately andinsert the contact-pin end of the card into the slot.NOTE: The slot is keyed to ensure correct insertion of the card.2. Press the card into the card slot to lock it into place.Next steps1. Follow the procedure listed in After working inside your system.LAN on Motherboard (LOM) riser cardThe LOM riser card installed in your system is an integrated network interface controller. You can removeand install the LOM riser card.Removing the LOM riser cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Keep the Phillips #2 screwdriver ready.Steps1. Remove the two screws that secure the LOM riser card to the system board.2. Lift the card from the system board.57
