Dell PowerEdge FC430 Owner's Manual

Also see for PowerEdge FC430: Getting Started With Your System Owner's manual

Contents

Dell PowerEdge FC430 Owner's Manual Manual pdf 89 page image

4. Connect the USB devices to the sled using a powered USB hub.5. If another sled is installed, connect the USB device to that sled. If the USB device works with adifferent sled, the first sled’s USB ports may be faulty. See Getting help.Troubleshooting an internal SD cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: SD card slot 2 referred in this procedure is the vFlash SD card slot. You can install an SD cardin SD card slot 2 to enable the Internal SD Card Redundancy option in the Integrated Devicesscreen of the System Setup.Steps1. Enter System Setup and ensure that the Internal SD Card Port is enabled.2. Note the Internal SD Card Redundancy option enabled in the Integrated Devices screen of theSystem Setup (Mirror or Disabled).NOTE: If you retain the original settings of the SD card in the System Setup, the replaced SDcard is enabled when you reinstall the sled in the enclosure.3. Remove the sled from the enclosure.4. If the Internal SD Card Redundancy option in the Integrated Devices screen of the System Setup isset to Mirror mode and SD card 1 has failed:a. Remove the SD card from SD card slot 1.b. Remove the SD card present in SD card slot 2 and insert it into SD card slot 1.c. Install a new SD card in slot 2.5. If the Internal SD Card Redundancy option in the Integrated Devices screen of the System Setup isset to Mirror mode and SD card 2 has failed, insert the new SD card into SD card slot 2.6. If the Internal SD Card Redundancy option in Integrated Devices screen of the System Setup is setto Disabled, replace the failed SD card with a new SD card.7. Install the sled in the enclosure.8. Enter System Setup and ensure that the Internal SD Card Port option is enabled and Internal SDCard Redundancy option is set to Mirror mode.9. Check if the SD card is functioning properly.If the problem persists, see Getting help.Troubleshooting processors1. Turn off the sled using the operating system commands or the CMC.2. Remove the sled from the enclosure.3. Ensure that the processor(s) and heat sink(s) are properly installed.4. If your system has only one processor installed, ensure that it is installed in the primary processorsocket (CPU1).5. Install the sled in the enclosure.6. Turn on the sled.89