Dell PowerEdge FC430 Owner's Manual

Also see for PowerEdge FC430: Getting Started With Your System Owner's manual

Contents

Dell PowerEdge FC430 Owner's Manual Manual pdf 79 page image

1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Remove the SSD backplane.4. Keep the Phillips #2 screwdriver ready.Steps1. Align the screws on the SSD backplane with the screw holes on the SSD cage.2. Press the SSD backplane into place until the retention screws on the SSD backplane engage with thescrew holes on the SSD cage.3. Ensure that the backplane connector is seated firmly in the socket on the system board and tightenthe two captive screws to secure the backplane to the SSD cage.Next steps1. Install the SSD carriers into their original bays.2. Follow the procedure listed in After working inside your system.Related LinksRemoving the SSD backplaneInstalling an SSD carrierNVRAM backup batteryThe NVRAM backup battery installed in your system helps to retain the BIOS settings and configurationseven if the power is switched off.Replacing the NVRAM backup batteryPrerequisitesWARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace thebattery only with the same or equivalent type recommended by the manufacturer. Discard usedbatteries according to the manufacturer's instructions. See the safety instructions that came withyour system for additional information.CAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Remove the cooling shroud.Steps1. Locate the system battery.2. Hold the battery and pull it toward the positive side of the battery till the battery disengages from theconnector.3. Lift the battery up and away from the system.4. To install a new system battery, hold the battery with the "+" sign facing the positive side of thebattery connector.79