120Item Connector Description15 USB2 USB port16 USB1 USB port17 TPM TPM connector18 J_BP Hard drive backplane connectorDisabling a forgotten passwordThe software security features of blade include a system password and a setup password. The password jumper enables thesepassword features or disables them, and clears any password(s) currently in use.PrerequisiteCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting andsimple repairs as authorized in your product documentation, or as directed by the online or telephone service and supportteam. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safetyinstructionsthatcamewiththeproduct.Steps1. Turnoff the blade by using the operating system commands or the CMC.2. Remove the blade from the enclosure to access the jumpers.3. Move the jumper on the system-board jumper from pins 2 and 3 to pins 1 and 2.4. Install the blade in the enclosure.5. Turnon the blade.When the blade is turned on, power indicator turns on to solid green. Allow the blade to finish booting.The existing passwords are not disabled (erased) until the system boots with the password jumper on pins 2 and 3. However,beforeyouassign anewsystem and/orsetup password, you must reinstall the password jumper back to pins 1 and 2.NOTE: If you assign a new system and/or setup password with the jumper on pins 1 and 2, the system disables thenew password(s) the next time it boots.6. Turnoff the blade by using the operating system commands or the CMC.7. Remove the blade from the enclosure to access the jumpers.8. Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3.9. Install the blade in the enclosure.10. Turnon the blade.11. Assignanewsystemand/orsetuppassword.
