57Figure 14. Removing a processor or DIMM blank1. processor or DIMM blank 2. heat sink retention socket (4)3. standoff (4)Next steps1. Install the processor and the heat sink.2. Ensure that you install the processor or DIMM blank when you have removed a processor permanently.3. Followthe procedure listed inthe After working inside your system section.Related linksSafety instructionsInstalling a processorInstalling a processor or DIMM blankBefore working inside your systemAfter working inside your systemInstallingaprocessoror DIMMblankPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting andsimple repairs as authorized in your product documentation, or as directed by the online or telephone service and supportteam. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safetyinstructionsthatcamewiththeproduct.NOTE: Youmust remove processor or DIMM blank when installing two processors or to serviceother components insidethe system.1. Follow the safety guidelines listed in safety instructions section.2. Followthe procedure listed in the Beforeworking inside yoursystem section.3. Your system does not have processor or heat sink installed.Steps1. Align the standoffs on the processor or DIMM blank with the heat sink retention sockets on the processor socket.2. Lower the processor or DIMM blank onto the system until the standoffs on the processor or DIMM blank engages with the heatsink retention sockets.
