Installing System Components 101Installing a VFlash Media Card1 Locate the VFlash media slot at the back corner of the system. See "Back-Panel Features and Indicators" for the location of the media slot.2 With the label side facing up, insert the contact-pin end of the SD cardinto the card slot on the module.NOTE: The slot is keyed to ensure correct insertion of the card.3 Press inward on the card to lock it into the slot.Removing a VFlash Media CardTo remove the VFlash media, push inward on the card to release it, and pullthe card from the card slot.iDRAC6 Enterprise Card (Optional)Installing an iDRAC6 Enterprise CardCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Remove the plastic filler plug from the system back panel.4 If installed, remove the expansion card from expansion-card riser 1. See"Removing an Expansion Card."5 Install the iDRAC6 Enterprise card:a Angle the card so that the RJ-45 connector fits through the back-panelopening. See Figure 3-12.b Align the front edge of the card with the two front plastic retentionstandoffs next to the iDRAC6 connector on the system board, andlower the card into place. See Figure 3-12 and Figure 6-1.
