Installing System Components 1033 Open the system. See "Opening the System."4 Remove the VFlash media from the iDRAC6 Enterprise Card.See"Removing a VFlash Media Card."5 If installed, remove the expansion card from expansion-card riser 2. See"Removing an Expansion Card."6 Remove the iDRAC6 Enterprise card:a Pull back slightly on the two tabs at the front edge of the card andgently lift the front edge of the card off of the retention standoffs.As the card releases from the standoffs, the connector under the carddisengages from the system board connector.b Slide the card away from the back of the system until the RJ-45connector is clear of the back panel, then lift the card out of thesystem.7 Reinstall the expansion card. See "Installing an Expansion Card."8 Close the system. See "Closing the System."9 Reconnect the system and peripherals to their power sources, and turnthem on.NIC Hardware KeyiSCSI and other functionalities for the system’s embedded NICs are enabledby installing an NIC hardware key in the iSCSI key socket on the systemboard.CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.NOTE: When future NIC functionality is added, you must install a new hardwarekey that adds that functionality.1 Turn off the system, including any attached peripherals, and disconnectthe system from its electrical outlet.2 Open the system. See "Opening the System."
