202 Management: Installing Array ComponentsInstalling a Hard DriveCAUTION: Many repairs may only be done by a certified service technician.You should only perform troubleshooting and simple repairs as authorized inyour product documentation, or as directed by the online or telephone serviceand support team. Damage due to servicing that is not authorized by Dell isnot covered by your warranty. Read and follow the safety instructions that camewith the product.CAUTION: Use only hard drives that have been tested and approved for use withthe MD3200i series.CAUTION: When installing a hard drive, ensure that the adjacent drives are fullyinstalled. Inserting a hard-drive carrier and attempting to lock its handle next to apartially installed carrier can damage the partially installed carrier's shield springand make it unusable.1 If applicable, remove the front bezel. See "Removing the Front Bezel" onpage 198.2 If applicable, remove the drive blank from the bay. See "Removing a DriveBlank" on page 199.3 Press the release button to open the drive carrier release handle .4 Insert the hard-drive carrier into the drive bay until the carrier contacts thebackplane.5 Close the handle to lock the drive in place.Removing a Hard Drive From a Hard-Drive CarrierRemove the screws from the slide rails on the hard-drive carrier and separatethe hard drive from the carrier. See Figure 16-5 for PowerVault MD3200i andFigure 16-6 for PowerVault MD3220i.
