68 Configuration: About Your Storage Array• In the AMW, select Storage ArrayBlinkStorage Array.The LEDs blink on the physical disks in the storage array.2 After locating the storage array, click OK.The LEDs stop blinking.3 If the LEDs do not stop blinking, select Storage ArrayBlink Stop AllIndications.A confirmation message is displayed.4 Click OK.Naming or Renaming Storage ArraysEach storage array should be assigned a unique up to 30-characteralphanumeric name. A name can consist of letters, numbers, and the specialcharacters underscore (_), dash (–), and pound sign (#). No other specialcharacters are allowed.To rename a selected storage array:1 Perform one of these actions:• In the AMW Setup tab, select Rename Storage Array.• In the EMW Devices tab Tree view, select Edit Rename• In the EMW Devices tab Table view, select Edit Rename.• In the EMW Devices tab Tree view, right-click on the desired arrayicon and select RenameThe Name/Rename Storage Arrays dialog appears.2 Select the relevant storage array from the Select storage array table.If you do not know the name or physical location of the storage array, clickBlink. After locating the storage array, click OK to turn off the LEDs.The name of the storage array appears in the Storage array name.3 In Storage array name, type the new name of the storage array. Ifapplicable, add a comment for the storage array in Additional comment.4 Click Apply.A message is displayed warning you about the implications of changing thestorage array name.
