74 Configuration: About Your Storage Array3 Click OK.4 If you have set a password for the selected storage array, the EnterPassword dialog appears. Type the current password for the storage array.5 Click OK.Configuring Alert NotificationsMDSM can send an alert for any condition on the storage array that requiresyour attention. Alerts can be sent as e-mail messages or as Simple NetworkManagement Protocol (SNMP) trap messages.You can configure alert notifications either for all the storage arrays or a singlestorage array.To configure alert notifications for all storage arrays:1 In the EMW, select the Setup tab.2 Select Configure Alerts.The Configure Alerts dialog is displayed.3 Select All storage arrays.4 Click OK.The Configure Alerts dialog is displayed. To configure e-mail alerts, see"Configuring E-mail Alerts" on page 74. To configure SNMP alerts, see"Configuring SNMP Alerts" on page 77.To configure alert notifications for a single storage array:1 In the EMW, select the Devices tab.2 Select the relevant storage array, then select EditConfigure Alerts.The Configure Alerts dialog is displayed. To configure e-mail alerts, see"Configuring E-mail Alerts" on page 74. To configure SNMP alerts, see"Configuring SNMP Alerts" on page 77.Configuring E-mail AlertsFor more information on configuring alert notifications, see "ConfiguringAlert Notifications" on page 74.To configure e-mail alerts:1 Open the Configure Alerts dialog by performing one of these actions:
