host="hostName"interfaceType=SASParametersParameter Descriptionidentifier WWID of the HBA host port. You must put quotation marks(" ") around the WWID.userLabel Name to give the new HBA host port. You must putquotation marks (" ") around the port label.host Name of the host for which you are defining an HBA hostport. You must put quotation marks (" ") around the hostname.NOTE: An HBA host port is a physical connection on ahost adapter that resides within a host system. AnHBA host port provides host access to the virtualdisks in a storage array. If the host bus adapter hasonly one physical connection (one host port), theterms host port and host bus adapter aresynonymous.interfaceType The identifier for the type of interface for the host port.You must enter SAS. If you do not enter SAS, thecommand attempts to use an invalid type of interface. ASAS selection requires an 8-byte WWID.NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replacesquare brackets ([ ]) with angle brackets (< >) to overcome this limitation.Create iSCSI InitiatorThis command creates a new iSCSI initiator object.Syntaxcreate iscsiInitiator iscsiName = "iSCSI-ID"userLabel = "name"host = "host-name"[chapSecret = securityKey]ParametersParameter DescriptioniscsiName The default identifier of the iSCSI initiator.userLabel The name that you want to use for the iSCSI initiator. Enclose the name indouble quotation marks (" ").host The name of the host in which the iSCSI initiator is installed.chapSecret The password that you want to use to authenticate a peer connection.112
