Parameter DescriptiondiskGroup Number of the disk group to be set to the optimal state.You must put brackets ([ ]) around the disk group number.Revive Disk PoolThis command forces a disk pool and its associated physical disks to the Optimal state.CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the diskpool. Do not try to revive a disk pool unless you are supervised by your Technical Support representative.Syntaxrevive diskPool [diskPoolName]ParameterParameter DescriptiondiskPool The alphanumeric identifier (including - and _) of the diskpool that you want to revive. Enclose thediskPoolName insquare brackets ([ ]).Revive Physical DiskThis command forces the specified physical disk to the optimal state.CAUTION: Correct use of this command depends on the data configuration on all physical disks in the disk group.Never attempt to revive a physical disk unless supervised by a Technical Support representative.Syntaxrevive physicalDisk [enclosureID,slotID]ParameterParameter DescriptionphysicalDisk Identifies the enclosure and slot where, the physical diskresides. Enclosure ID values are 0 to 99. Slot ID valuesare 0 to 31. You must put brackets ([ ]) around theenclosure ID value and the slot ID value.Save Enclosure Log DataThis command saves the enclosure log sense data to a file. Log sense data is maintained by the environmental cards foreach enclosure. Not all of the environmental cards contain log sense data.Syntaxsave allEnclosures logFile="filename"Parameter157
