Network Administration: VLAN 147FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\UserGuide\Dell_Astute_Network_Admin_VLAN.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 8 / 9 / 1 6 - F O R P R O O F O N L YAcceptable Frame TypeThe acceptable frame type can be set on a port to accept all frames (taggedand untagged), tagged only, or untagged only. This setting takes precedenceover all other settings, so that if the acceptable frame type is tagged only,incoming untagged frames are silently discarded, even if the port has a validPVID.Standard VLANThis section describes standard (non-voice) VLANs. It covers the followingtopics:• VLAN Membership• VLAN Port Settings• Protocol Group• Protocol Port• GVRP Parameters• GARP Timers• Private VLANVLAN MembershipThe device supports up to 4094 VLANs (VLANs 1-4094).Ports are assigned to a VLAN in the VLAN Port Settings page.To configure the ports in a VLAN:1 Click Network Administration > VLAN >Standard VLAN > VLANMembership.Each existing port/LAG is labeled with one of the following codes,regarding its membership in the VLAN:– T — Tagged. The interface is a member of a VLAN. All packets egressto the interface are tagged. The packets contain VLAN information.– S — Static. The VLAN is user-defined.– U — Untagged. The interface is a member of a VLAN. Packets egressto the interface are untagged.– F — Forbidden. The interface is denied membership to a VLAN.
