Using the CLI 331FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\UserGuide\Dell_Astute_Using_CLI.fmD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 8 / 9 / 1 6 - F O R P R O O F O N L YAccessing the Device Through the CLIYou can manage the device using CLI commands via a Telnet connection andvia a console connection.The device supports up to four simultaneous Telnet sessions. All CLIcommands can be used over a Telnet session.IPv6 Address ConventionsIf the IPv6 address is a Link Local address (IPv6z address), the outgoinginterface name must be specified.The format of an IPv6z address is:{ipv6-link-local-address}%{interface-id}.The subparameters are:• ipv6-link-local-address—Specifies the IPv6 Link Local address.• interface-id—{<port-type>[ ]<port-number>}|{port-channel |po}[]<port-channel-number> | {tunnel | tu}[ ]<tunnel-number> |vlan[ ]<vlan-id>If the egress interface is not specified, the default interface is selected. Thefollowing combinations are possible:• ipv6_address%interface_id — Refers to the IPv6 address on the interfacespecified.• ipv6_address%0 — Refers to the IPv6 address on the single interface onwhich an IPv6 address is defined.all When a parameter is required to define a range of ports orparameters and all is an option, the default for the commandis all when no parameters are defined. For example, thecommand interface range port-channel has the option ofeither entering a range of channels, or selecting all. When thecommand is entered without a parameter, it automaticallydefaults to all.Button Description
