Denon AVR-1707 Operating Instructions Manual

Also see for AVR-1707: Service manual Service manual Operating instructions Brochure & specs Dimensions

Contents

ENGLISH19ENGLISHBasic OperationPlaying the input sourceUse INPUT SELECTOR to select the input source youwant to play.Start playback on the selected component.For operating instructions, refer to the component’s manual.13Press INPUT MODE.AUTO (All auto mode):The type of input signal is detected and the AVR-1707’s surroundmode is switched automatically. Can be selected for sources forwhich the Digital In Assignment mode ( page 41) is made.The mode switches automatically to DTS/ Dolby Digital/ PCM.The input switches to the analog input terminals is no digitalsignals are being input.• The INPUT mode indicator lights.ANALOG (exclusive analog audio signal playback mode) andEXT. IN (External decoder input terminal selection mode):The signals input to the various input terminals are played.PCM (exclusive PCM signal playback mode) andDTS (exclusive DTS signal playback mode):Played when the various signals are input. Noise may begenerated when a mode different from the input signal is set.• The INPUT mode indicator lights.AUTOEXT. IN ANALOGPCM DTS2Use VOLUME to adjust the volume.• The volume level is displayed on the master volume leveldisplay.The volume can be adjusted between the range of –80 ~ 0 ~ 18dB. Depending on the channel level settings and the differentsurround mode settings and when in the down-mix mode, it maynot be possible to adjust the volume to 18 dB.4NOTE:• When the input mode is set to the external input (EXT. IN), thesurround mode cannot be set.• In play modes other than the external input mode, the signalsconnected to these terminals cannot be played.Cautions when playing DTS sources:• For DTS sources, be sure to connect the device to the digitalinput terminal and set “AUTO” or “DTS” for the input source.Noise will be generated if you play in the “ANALOG” or “PCM”mode.• When playing DTS signals in the “AUTO” mode, noise may begenerated when you first start playing and during searching. If so,play in the “DTS” mode.• Canceling the EXT. IN mode:Press INPUT MODE or to switch to the desired inputmode.• To use the EXT. IN mode together with a picture, select the inputsource to which the video signal is connected first, then set theinput mode.• The “DIGITAL” indicator lights when digital signals are being inputproperly. If the “DIGITAL” indicator does not light, check whetherthe “Digital In Assign” ( page 41) and connections are correct.Press to select “ANALOG”, to select “EXT.IN”.To lower the subwoofer channel level in the EXT. IN mode, pressSURROUND PARAMETER and select “SW. ATT”.For some players the playback level of the SW channel mayseen strong. If so, set to “ON”.About the button names in this explanation< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only :Buttons on the main unit and remote control unitDIMMERVOLUME[MUTING]STATUSINPUT SELECTORINPUT MODESURROUNDPARAMETERINPUT SELECTORSURROUND PARAMETER STATUSDIMMERINPUT MODEINPUT SELECTOR VOLUME