Denon AVR-1707 Operating Instructions Manual

Also see for AVR-1707: Service manual Service manual Operating instructions Brochure & specs Dimensions

Contents

ENGLISH37ENGLISH¢ Last function memoryThe various settings set when the AVR-1707’s power is switched tostandby are stored in the memory. When the power is turned back on,the settings made when the power was switched to standby arerecalled.About the memory functionsRecording the program source (recording thesource currently being monitored)¢ Backup memoryThe various settings are stored in the memory for about 1 week, evenwhen the power is turned off or the power cord is unplugged.Advanced Operation Advanced OperationInitialization of the microprocessor (Reset)If the indication on the display is not normal or if the operation of theunit is not correct, then the microprocessor should be reset by thefollowing procedure.Switch off the unit using .1Check that the entire display is flashing at 1-secondintervals and release the buttons.• The microprocessor will be initialized.3Keep both (A and B) depressed and turnon the unit by pressing .2• If step 3 does not work, start over from step 1.• If the microprocessor has been reset, all the button settings arereset to the default values (the values set upon shipment from thefactory).Select the input source to be played.1Start recording on the tape or video deck.For instructions, refer to the component’s operating instructions.3Select the input mode and play (surround) mode.2• The AUDIO IN’s signal selected with INPUT SELECTOR are output tothe CD-R/TAPE and VCR AUDIO OUT terminals.• Digital signals are not output to the audio output terminals.¢ Simultaneous recordingThe signals of the source selected with INPUT SELECTOR are outputsimultaneously to the CD-R/TAPE and VCR REC OUT terminals. If atotal of two tape and/or video decks are connected and set to therecording mode, the same source can be recorded simultaneously onevery decks.About the button names in this explanation< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only :Buttons on the main unit and remote control unitINPUT SELECTORINPUT SELECTORINPUT SELECTOR