Denon AVR-1707 Operating Instructions Manual

Also see for AVR-1707: Service manual Service manual Operating instructions Brochure & specs Dimensions

Contents

1 7 T . T O N E Y e s <1ENGLISH47ENGLISHAdvanced Setup – Part 2 Advanced Setup – Part 2Set the volume of the various speakers so that the sound output fromthe speakers and the subwoofer seems to have the same volumelevel.Press FF GG to set, then press HH.When “Auto” mode is selected:Press FF GG to adjust the volume.• Test tones are output automatically, in the order shown below.Auto:Adjust the level while listening to the test tones producedautomatically from each speaker.Test tones are automatically emitted from each speaker.Manual:Adjust with the speaker from which the test tone is outputswitched manually.FLSWC FR SRSBLSLSBSBRSetting the Test ToneThe volume can be adjusted within the range –12 dB to +12 dB.When “Manual” mode is selected:Press DD HH to select the speaker, then press FF GG toadjust the volume.Press ENTER to finish the Test Tone setting.23-13-24(2 speakers)(1 speaker)¢ Adjusting the test tone using the remote controlunitAdjustment of the test tones using the remote control unit is onlypossible in the “Auto” mode and only valid in the STANDARD (DolbySurround and DTS Surround) mode. The adjusted levels areautomatically stored for the different surround modes.Press [TEST TONE].• Test tones are output from the different speakers.Press [TEST TONE].Press FF GG to adjust the volume.123• To adjust the channel level separately for the different play modesafter setting the channel level, perform the operation on page 30.T . T o n e A u t o >2T E S T T O N E O N3A U T O - F L• The distance changes in units of 1 foot (0.1 meters) each time thebutton is pressed. Select the value closest to the measureddistance.• Please note that the difference of distance for every speakershould be 20 ft (6.0 m) or less.Setting the Crossover FrequencySet the frequency (Hz) below which the bass sound of the variousspeakers is to be output from the subwoofer.For speakers that are set to “Small”, frequencies under the crossoverfrequency are cut before the signal is output, and the low frequencycomponent that was cut is output from the subwoofer or thespeakers that are set to “Large”.40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:Set as desired according to your speakers’ bass playback ability.Press ENTER or HH to enter the setting and switch tothe Test Tone setting.2• The crossover frequency mode is valid only when subwoofer is setto “ON”, and when one or more speakers are set to “Small”, asdescribed in section “Setting the Speaker Configuration” ( page45, 46).• Set to “80 Hz” when using regular speakers. When using smallspeakers, we recommend setting to a higher frequency.Press FF GG to set.11 6 C r . O v e r 1 0 0 H z11 7 T . T o n e Y e s <2Press FF to select “Yes”.1Press ENTER the setting and switch to the Input Setup.55