ENGLISH46ENGLISHAdvanced Setup – Part 2Setting the Subwoofer Mode SetupSelect the method of playback of the subwoofer for playing the lowbass signals.LFE (Normal):For any channel(s) that are set to “Large”, low frequencies in thatchannel’s corresponding source are directed to that loudspeakeronly. The low frequencies played from the subwoofer are only theLFE signals and the low frequencies of channels set to “Small”.LFE+Main:Low frequencies from speaker channels that have been set to“Large” are reproduced from those speakers as well as from thesubwoofer(s).• The subwoofer mode setting is only valid when and “Yes” is set forthe subwoofer in the “Setting the Speaker Configuration”.• Select the “LFE+Main” mode if you want low frequency signals toalways be played from the subwoofer channel.• Select the mode achieving a voluminous bass sound when playingmusic or movie sources.Press ENTER or HH to enter the setting and switch tothe Distance setting.2Setting the DistanceThis parameter is for optimizing the timing with which the audiosignals are produced from the speakers and subwoofer according tothe listening position.Preparations:Measure the distances between the listening position and thespeakers (L1 to L8 on the diagram at the below).L1 L2L3L4L5 L6L7 L8C FRFLSWListening positionSL SRSBL SBRAdvanced Setup – Part 2Press ENTER or HH to enter the setting and switch tothe Crossover Frequency setting.21 5 S W 1 2 f t• Select “Large” or “Small” not according to the actual size of thespeaker but according to the speaker’s capacity for playing lowfrequency (bass sound below the frequency set for the CrossoverFrequency) signals. If you do not know, try comparing the sound atboth settings (setting the volume to a level low enough so as not todamage the speakers) to determine the proper setting.S p e a k e r S e t u p1 F r o n t L a r g e26 S u b w o o f e r Y e s1Press FF GG to set.17 S W M o d e +Main18 F L 1 2 f t2Press FF GG to set.11 6 C r . O v e r 8 0 H z28 F L 1 5 f t17 S W M o d e N o r m3