14ENGLISHSetting the Test Tone• Use this setting to adjust to that the playback level between the different channel is equal.• From the listening position, listen to the test tones produced from the speakers to adjust the level.• The level can also be adjusted directly from the remote control unit. (For details, see page 23.)1 Select “Yes”.15 T.TONE 2 Set the mode.Select “Auto” or “Manual”.T.TONE AUTO• Auto:Adjust the level while listening to the test tonesproduced automatically from the different speakers.• Manual:Select the speaker from which you want to produce the test tone to adjust thelevel.3 Press the (down) button to start Test Tone.4 a. If the “Auto” mode is selected:Test tones are automatically emitted from the different speakers.The test tones are emitted from the different speakers in the following order, at4-second intervals the first time and second time around, 2-second intervals thethird time around and on:FL C FR SR SB SL SWUse the CURSOR left and right buttons to adjust all the speakers to the samevolume.The volume can be adjusted between –12 dB and +12 dB in units of 1 dB.1spkrb. When the “Manual” mode is selectedUse the CURSOR up and down to select thespeaker for which you want to output test tones,then use the CURSOR left and right to adjust sothat the volume of the test tones from the variousspeakers is the same. Example:When the volume is set to –12dB while the Front Lch speaker isselected5Press the ENTER or (down) button to enter the setting and switch theDIGITAL input setting.6After completing the adjustment, press the ENTER button.NOTES:• When you adjust the channel levels while in the TEST TONE mode, the channel level adjustments madewill affect all surround modes. Consider this mode a Master Channel Level adjustment mode.• You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, DOLBY/DTSSURROUND, 5/6 CH STEREO, MONO MOVIE, ROCK ARENA, JAZZ CLUB, VIDEO GAME, MATRIX andVIRTUAL.Setting the Digital In Assignment• This setting assigns the digital input jacks of the AVR-1804 for the different input sources.1 Select the digital input jack to be assigned to theinput source.• To select the digital input jack16 COAX CD2 • To select the input sourceSelect “OFF” if nothing is connected.3 Press the ENTER or (down) button to enter the setting and switch theComponent Video input setting.NOTE:• PHONO, TUNER and V. AUX cannot be selected.
