Denon AVR-1804 Operating Instructions Manual

Also see for AVR-1804: Specification sheet Operating instructions Operating instructions Service manual Operating instructions

16ENGLISHAfter setting up the system1 Press the SYSTEM SETUP button to finish system set up.This completes the system setup operations. Once the system is set up, there is no need to make thesettings again unless other components or speakers are connected to or the speaker layout is changed.REMOTE CONTROL UNIT113213Operating DENON audio components3 Operate the audio component.• For details, refer to the component’s operating instructions.While this remote control is compatible with a wide range of infrared controlled components, somemodels of components may not be operated with this remote control.1. CD player (CD) and CD recorder and MDrecorder (CDR/MD) system buttons2. Tape deck (TAPE) system buttons6, 7 : Manual search(forward and reverse)2 : Stop1 : Play8, 9 : Auto search (cue)3 : PauseDISC SKIP + : Switch discs(for CD changers only)6 : Rewind7 : Fast-forward2 : Stop1 : Forward play0 : Reverse playA/B : Switch between decks A and B• Turn on the power of the different components before operating them.1 Set mode switch 1 to “AUDIO”.2 Set mode switch 2 to the position for thecomponent to be operated. (CD, CDR/MD orTape deck)3. Tuner system buttonsSHIFT : Switch preset channel rangeCHANNEL +, – : Preset channel up/downTUNING +, – : Frequency up/downBAND : Switch between the AM and FMbandsMODE : Switch between auto and monoMEMORY : Preset memoryNOTE:• TUNER can be operated when the switch is at “AUDIO” position.Auto Tuner Presets• Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels A1 to 8, B1to 8, C1 to 8, D1 to 8 and E1 to 8.NOTE:• If an FM station cannot be preset automatically due to poor reception, use the “Manual tuning” operation totune in the station, then preset it using the manual “Preset memory” operation.1 Use the CURSOR button to select “Yes”.“Search” flashes on the screen and searchingbegins.“Completed” appears once searching is completed.The display automatically switches to screen.25 PRESET 2 Press the ENTER or (down) button if you want to start the settings over fromthe beginning.• On-screen display signalsSignals input to the AVR-1804VIDEO signal input jack(yellow)ECEC1234S-video signal input jackEECCVideo signal output toVIDEO MONITOR OUT jack(yellow)CCCEOn-screen display signal output(C: Signal E: No signal) (C: On-screen signals output E: On-screen signals not output)Video signal output to S-Video MONITOR OUT jackCCCC